Your Cart

Head Cap for Nexus

Head Cap for Nexus
Head Cap for Nexus


Values are in US Dollars for direct import by the end consumer and are subject to import duties and customs duties.

(the amount can be paid in installments or financed - Find out here how to finance)

Helmet with up to 21 channels of recording for neurofeedback and brain mapping with carbon coating to avoid interference, used with the Nexus 32.

The NeXus EEG Cap was specially designed for the Nexus-32. It is a 32channel EEG cap according to the 10-20 system (locations are shown on the cap.) This cap does not need electrodes as they are already part of the cap. The electrodes are sintered and therefore the cap can be used hundreds of times. The cover is made of stretchy and comfortable material and comes in three sizes; small, medium and large size. The rubber suction cups on the inside of the lid keep the lid in place and make sure that no electro-gel escapes. All cables are carbon coated and use our active noise canceling technology. All cables are very well held together.

Set-up: First connect the Nexus EEG Cap Adapter to the Nexus-32. Place the cap over the head and fill the mounts with electro-gel or abralyt using a syringe with a blunt needle. Meanwhile the impedance/electrode offset can be checked online on the NeXus-32. Finally, connect the cap to the adapter and you're done.

Clean the lid with warm water. When drying the cap, be sure to keep the connector dry. Therefore, always hang the connector higher than the cap itself.

Easy EEG cap for up to 21 channels.

This is a high quality and flexible EEG cap that uses special sintered ring-electrodes with carbon coating and active shielding. It offers virtually artifact free (motion) EEG recording with NeXus-32. Sizes from 36-62 cm. (In 2 cm steps).

Match with

  • Adapter for NeXus EEG Cap
  • NeXus-32
  • Syringe
  • Blunt needles
  • Electrogel
  • Abret

Write a review

Note: HTML is not translated!
Bad Good